Analytical validation of an ultraviolet-visible procedure for determining vitamin D3 in vitamin D3-loaded microparticles and toxigenetic studies for incorporation into food.

Vitamin D is a water-insoluble compound presented in two main forms (D2 and D3), susceptible to environmental conditions. Microencapsulation is an alternative to supplements and preserve vitamin D properties in foods. Entrapment efficiency (EE) is the main property to evaluate the encapsulation effectiveness and therefore it is of interest the study of analytical methods for the identification and quantification of this compound within the particle. This paper describes a low cost UV-Vis methodology validation to the identification and quantification of vitamin D3 in microparticles produced by hot homogenization. The method was validated following the International Conference on Harmonization (ICH) guidelines. To guarantee safe application in foodstuff, microparticles toxigenicity was evaluated with Allium cepa L. in vivo model, showing no cytotoxic nor genotoxic potential. High entrapment efficiency was obtained, the results also demonstrated that the concentration of vitamin D3 in microparticles can be safely accessed by the validated method.

Modulation of aroma release of instant coffees through microparticles of roasted coffee oil.

We report, on the successful addition of spray-dried microparticles containing roasted coffee oil, to soluble coffee (SC) and instant cappuccino (IC), to increase and tailor aroma release. Using PTR-ToF-MS (Proton Transfer Reaction Time-of-Flight Mass Spectrometry), five parameters were defined from time series intensity for each VOC, to compare the performance of different products: total area under the curve (AUC), area under the curve of burst (AUC-burst), maximum signal intensity, final intensity (5 min), and ratio AUC-burst/AUC. Microparticles with higher loads of roasted coffee oil were effective in increasing aroma intensity in SC while, for IC, all loads of microparticles improved aroma intensity. Volatility drove the VOC release in SC, and volatility and polarity for IC. Most compounds reached maximum headspace concentration in < 16 s upon start of reconstitution. These results open new perspectives for the development of instant coffee products and demonstrate their unique aroma release characteristics.

Novel experimental approach to study aroma release upon reconstitution of instant coffee products.

This study presents an experimental approach to study the kinetics and fast release of volatile organic compounds (VOCs) upon reconstitution of instant coffee products. A sampling setup coupled to PTR-ToF-MS (Proton Transfer Reaction Time-of-Flight Mass Spectrometry) for the automated and reproducible reconstitution of instant coffee products was developed to monitor the dynamic release of VOCs. A rapid release of aroma compounds was observed in the first seconds upon hot water addition ("aroma burst"), followed by subsequent decrease in headspace (HS) intensities over the course of analysis. Differences in time-intensity release profiles of individual VOCs were correlated to their Henry's Law constant, vapor pressure and water solubility. The setup and approach proposed here have shown to be sensitive and to respond to fast dynamic changes in aroma release. It allows studying VOCs release upon reconstitution and supports the development of novel technologies and formulations for instant products with improved aroma release properties.

Characterization of Roasted Coffea arabica Species by the Relationship Between Caffeine and Diterpenes Contents

Abstract Commercial roasted and ground coffees are usually blends of Coffea arabica and Coffea canephora. Considering the differences in price and sensory characteristics between these two species, the identification of the presence of each species in commercial blends is of great interest. The aim of this study was to describe typical profiles of caffeine and diterpenes (kahweol and cafestol) contents and the ratios among these compounds to support the characterization of Coffea species in roasted coffees. 32 good cup quality Brazilian C. arabica coffees (from coffee quality contests) produced using different postharvest treatments were studied. All analysis were performed by HPLC. Higher ranges were observed in diterpene contents - kahweol varied from 1.75 to 10.68 g/kg (coefficient of variation of 510%) and cafestol from 1.76 to 9.66 g/kg (449%) - than caffeine, that varied from 5.1 to 16.2 g/kg (coefficient of variation of 218%). Wide ranges of the kahweol/cafestol ratio (0.63 to 2.77) and the caffeine/kahweol ratio (0.84 to 5.15) were also observed. Hence it was proposed the additional use of a new parameter, the ratio of caffeine/sum of diterpenes (kahweol + cafestol) that presents values from 0.54 to 2.39. The results indicated that the combined use of these parameters could be a potential tool for discriminating Coffea species in blends of roasted and ground coffee. It was proposed as potentially indicative of C. arabica: values of kahweol/cafestol ratio above 0.50, associated with caffeine/kahweol ratio lower than 5.50 and caffeine/sum of diterpenes ratio lower than 2.50.